Initially Posted By barniicz: Hello, Thanks for the answer. I am sorry, but I haven't found out tips on how to add photos. These weapons I've never observed the cabinets of our outlets. There were weapons of recent manufacturers - Dlask, Proarm Armory, Norinco ap., But not Colt M16A1. I think it was a really minimal provide of recent weapons. I wished to know the origin of those weapons, but I didn't find the precise details.

Of course, I am guaranteed the higher receiver is Colt, along with the BCG.  It is actually the barrel that may be questionable to me.

I've owned many M16's in each configuration along with the something I've acquired over the years is that there's no one which knows it all, simply because there has never been a concrete rule with Colt

Individually, I would not utilize a drill push. It could be finished, but I'd personally go the router or mini mill route.

Keen eye :) The "re-profile" (so to talk) on my specific colt was executed somewhat a lot better than that case in point, but The purpose is no less than particular important attributes/things ended up attempted being reproduced faithfully.

I am hoping these opinions are not directed to me inquiring my issue. Trigger I did not see The solution right here.

What about the handguards? are the heat defend mounted with rivets as we have already been triggered imagine? How can they compare to the actual detail?

Any sales opportunities on someone who might make a very good eighty% Colt marked lower? I'm commencing my journey creating a circa-1968 M16A1 and am striving to find a decrease. I am keen on seeking to resource a reduced with all the correct Colt markings.

The total Mag Fence was the third from the A1 lower collection. This receiver differs in the later A2 receiver with its insufficient reinforcement modifications with the rear receiver extension lug as well as the front pivot pin lugs. The A2 decrease receiver is over and above the scope of this article.

The extent from the modifications to get performed will depend on which design or type of reduced receiver is being reproduced.

Quoted: I manufactured several opinions about on youtube, but I will position a handful of listed here as well: I have the similar rifle (my serial quantity is about two hundred better) and I am able to assure you the slip ring and result in guard on mine are grey as well as a stable match for the higher/decreased receiver, I'm also quite content with the lessen roll marks on mine. They may be nicely completed and appear like the rest of my colts rifles.  A further position which i want to make the Colt is applying an genuine A1 reduce NOT a "doctored up" re-machined A2 (such as Brownells and Some others).

Fulton Armory displays an A1 kind rifle, but I can't explain to from their Internet site when they provide the reciever only.

four. Is really a Colt SP1 slabside reduce which was marketed for the civilian industry the same as the original Colt A1 "slabside" M16 decrease that was sold into the army?

The model designation is dependent upon how it had been configured here when it left the factory. This really is Tony K, And that i authorised this information.